Subject: Improved tilt-rotor-VTOL gear box.
From: Rotary Engine
Date: 9/24/2007, 3:39 PM
To: AARotary Engine

I am getting a Lenco catalog on the way.
Lenco has a 91 tooth ring gear and a 23 tooth sun gear for
an over all ratio of 3.95:1. Counter rotating the blade
ratio is 7.98 for each blade. That allows us to use a larger
rotor diameter and still keep the tips to .8 mach or
so at 300 MPH. The diameter of the 91 tooth ring
gear is about 8 inches so it is a bit larger and heavier than the Ford
set which is around  5 inches OD. That makes it pretty bullet prof so we
may not need the Lenco one inch wide set. The 3/4 set might be fine.

In any event here is the new tip speed chart so we can go up about a foot
on the rotor diameter without using the telescopic blade idea.

This configuration holds the most promise for solving the general aviation
dilemma. http://www.rotaryeng.net/VTOL.html

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.