I am getting a Lenco catalog on the way.
Lenco has a 91 tooth ring gear and a 23 tooth sun gear for
an over all ratio of 3.95:1. Counter rotating the blade
ratio is 7.98 for each blade. That allows us to use a larger
rotor diameter and still keep the tips to .8 mach or
so at 300 MPH. The diameter of the 91 tooth ring
gear is about 8 inches so it is a bit larger and heavier than the Ford
set which is around 5 inches OD. That makes it pretty bullet prof so we
may not need the Lenco one inch wide set. The 3/4 set might be fine.
In any event here is the new tip speed chart so we can go up about a foot
on the rotor diameter without using the telescopic blade idea.
This configuration holds the most promise for solving the general aviation
dilemma.
http://www.rotaryeng.net/VTOL.html
Paul Lamar ...No rotor no motor.
I made a mistake. I am disappointed in you guys for not catching this :)
There was a bug in my tip speed calculation program. It over estimated tip speeds.
The stock Ford 3.17 planetary is fine the way it is. We don't need no stinking
Lenco gears :) Much cheaper. The last jpg is the corrected chart. I'll have to
fix the web site.
This is looking better and better all the time. We can use a 13 foot diameter
rotor for a disk loading of less than a Robinson or up the gross weight
a couple of hundred pounds. We could smoke everybody off in the Dayton to OSH race.
They would not know what hit them. We don't need no stinking Reno.
Next problem is lay out the cooling and fuel tanks. I am going to engine
fan cool it during take off and disconnect the fan for forward flight.
We need to set up a corporation to develop this. Do we have any CEO
types on here?
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.