Subject: Lancair nose gear.
From: Rotary Engine
Date: 9/27/2007, 10:13 PM
To: AARotary Engine



   So Mark I take it the spiral in the exhaust down pipe was not
   totally
   satisfactory as far as noise is concerned? Is it still in there?

   BTW How many hours do you have now? How is your fuel injection
   working?

   --
   Paul Lamar ...No rotor no motor.


   Paul,

   I would call the spiral flow muffler "marginally adequate". Noise
   levels were not exceptionally loud, but after hearing the
   Renesis-Hush Power II run, I am envious. Also, the spiral flow
   design is showing some signs of flaking and metal fatigue after 1.5
   hrs in the air. Until I test the Hush Power II, I plan on welding
   up another spiral flow design, but using 321 SS instead. It is
   truly amazing how hot the exhaust gas gets. It has melted two AN-3
   bolts which were 1/2" inside the exhaust pipe outlet. I
   switched to
   a stainless steel 1/4-28 bolt and it looks like it can handle the
   heat.


   As for the ignition, it is doing fine, now that I figured out what was
   causing my misfiring condition at high rpm (6500 & up).

   On another subject, some of the Lancair ES's have developed cracks in
   their motor mounts. I may need to remove my mount and send it back for
   magna-fluxing and repair. There have been a number of severe shimmy
   incidents, one resulted in nose gear collapse. They're still trying to
   figure out why that's happening. I have not experienced any shimmy in
   six landings, but they usually begin later on, after 100 or so
   landings. Personally, I believe that the mounts are cracking which
   weakens the mount and allows the shimmy to occur. The cracks are on the
   cross-over tube right at the nose strut attachment. I'll be
   inspecting mine for cracks this weekend. Hopefully, I won't have to
   ground it for mount/strut repairs.

   Other than that, it flies great!

   Mark S.

   Sorry about messing up the margins. ;-(

    From just looking at these pictures of the MM
   it does not look like it has any positive damping in rotation other
   than the friction in the cylinder seals. Once the seals wear a bit
   the friction is probably reduced. A scissor link and a circular
   disk damper could be retrofitted. I'll do a 3D for you.

   The structural design is not great either. It needs an FEA done
   as there are tubes in bending and torsion. I take it you are using the
   stock Continental bed mount. I have never been a fan of that mount.
   Also some of the bays are not triangulated. CC copied it unfortunately.

   I take it you steer with the brakes?

   Has Tom Parke's had any nose gear problems. Tom?

   Paul Lamar ...No rotor no motor.




   Paul,
   It really wasn't that loud. But after hearing Dennis's Hush Power II,
   I'm suffering from muffler envy. One other thing I noticed that I left
   the inside pipe open instead of welding a plug on the inlet side like
   the commercial model has. So, I'll try it one more time to see how Rev
   2 works and will report back. One thing I must say for the spiral flow
   muffler is that it is very light weight.

   Mark

   Don't get your hopes up too high. That was an RX8 motor and way less HP.
   --
   Paul Lamar ...No rotor no motor.


   Mark,

   Sorry, I must have missed the info on your ignition problem.  What
   was the cause and solution to your high speed missing condition.

   thanks, Joel



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.