Subject: Grinding Brass or Aluminium,
From: Rotary Engine
Date: 9/28/2007, 8:59 AM
To: AARotary Engine


This was on another aviation list I'm on...  I never thought you could
grind these soft metals.

-dave

-------- Original Message --------

Grinding Brass or Aluminum,

The best thing to use is the fat cut off a piece of meat, before you start
the grinder rub the fat into the stone. It stops the metal sticking in the
grinder. The only thing you have to watch is when the start grinding the fat
heats up & flies everywhere. It might last 1/2hr & then you have to repeat
the process, you will soon find out through trial & error

When you cut the fat off the piece of meat make sure there is no meat on it
or else it will go off very quickly. The fat will last for a long time &
won't go off.

I used to do a lot of casting from the foundry & this was the best thing to
use.

Robin.


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.