On another subject, some of the Lancair ES's have developed
cracks in
their motor mounts. I may need to remove my mount and send it
back for
magna-fluxing and repair. There have been a number of severe shimmy
incidents, one resulted in nose gear collapse. They're still
trying to
figure out why that's happening. I have not experienced any
shimmy in
six landings, but they usually begin later on, after 100 or so
landings. Personally, I believe that the mounts are cracking which
weakens the mount and allows the shimmy to occur. The cracks are
on the
cross-over tube right at the nose strut attachment. I'll be
inspecting mine for cracks this weekend. Hopefully, I won't have to
ground it for mount/strut repairs.
Other than that, it flies great!
Mark S.
Sorry about messing up the margins. ;-(
From just looking at these pictures of the MM
it does not look like it has any positive damping in rotation other
than the friction in the cylinder seals. Once the seals wear a bit
the friction is probably reduced. A scissor link and a circular
disk damper could be retrofitted. I'll do a 3D for you.
The structural design is not great either. It needs an FEA done
as there are tubes in bending and torsion. I take it you are
using the
stock Continental bed mount. I have never been a fan of that mount.
Also some of the bays are not triangulated. CC copied it
unfortunately.
I take it you steer with the brakes?
Has Tom Parke's had any nose gear problems. Tom?
Paul Lamar ...No rotor no motor.
Paul, Mark, etc.,
I logged 80 hours and probably nearly that many landings on my ES before the
Ross PSRU problem arose. No shimmy noted to date and no cracking of the
mount, which was modified for the 20B. You can bet I'll be watching it
closely from here on out.
Tom Parkes
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.