Subject: Hushpower from Flowmaster RotaMax fuel burn.
From: Rotary Engine
Date: 10/3/2007, 6:52 AM
To: AARotary Engine




    >     Eric,
    >     Is that fuel burn ratio's 13.1:1 to 13.4:1 at WOT?
    >     George (down under)
    >
    >
    >     George,
    >
    >     13-1 at WOT is pretty close number. We will have more dyno, test
    >     stand, and
    >     in flight data in the coming months.
    >
    >     Eric Barger
    >
    >
    >
    > I know this is probably picking nits, but I'd like everyone to think
    > about mixture (fuel-air) in terms %power (or best-power) instead of
    > throttle position (re "WOT" in this message).  Throttle position -
    > especially on the rotary which runs well over a wide range of mixture
    > settings, is only a portion of the description or power output.
    >
    > WOT should be thought of as "best volumetric efficiency" not "best
    > power" - though best power generally happens at WOT.
    >
    > So, it sounds like Eric is saying that he sees his engines making
   best
    > power at mixtures around 13:1.
    >
    > Side question Eric:  Does your engine test setup allow easy inflight
    > setting/adjustment/control of the fuel-air mixture?  As has been
    > discussed here in the past, this is critical for optimizing engine
    > performance (efficiency) lacking some kind of really smart FADEC
   system.
    >
    >
    > Regards,
    >
    > Matt-

   Matt,
   I agree, I asked the question as I thought best power for the rotary
   was
   12.65:1.
   I intend running a carb with a wide band O2 sensor and a digital display
   monitor/readout.
   No good having a leaning knob, unless you can see what the fuel air
   ratio
   is - my opinion only FWIW.
   George (down under)


   Matt,

   Good input as it relates to VE and WOT. We tune our ECU using VE
   correction
   with a desired lambda as a base map. Our ECU has an external Barometric
   sensor allowing for altitude comp without having to do any in flight
   adjustments. One note about A/F mixture in a charged cooled rotary
   engine
   the incoming A/F is cooling the rotor so you use this to provide
   cooling as
   well as desired and or optimum power. This is one variable we have
   that is
   not in the Mazda rotary due to the oil cooling.

   Eric Barger



Thanks for the info Eric.  When reducing power, is the first step to
lean the mixture, assuming there's enough thermal margin to not overheat
the engine?

I wonder how much of the charge cooling is caused by evaporation of fuel
vs. just mass flow through the rotor..  If the power output is being
reduced by limiting fuel flow (leaning), will the rotor temperature be
controlled?


Regards,

Matt-


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.