>
    > > http://gizmodo.com/gadgets/fourstroke-action/micro-camera-shows-
    > the-workings-of-a-combustion-engine-309138.php
    > >
    > >
    > >
    > >
    > >  Too bad we can?t put a camera on one chamber ourselves?..! Also
    > what> happened to the exhaust stroke?
    > >
    > > Marc W.
    >
    > Yes, you are right.
    > They show the exhaust valve from close to open but not the full
    > exhauststroke.
    > Perhaps it was felt there was nothing to see and the film jumps
    > back to
    > the beginning of the opening of the inlet valve on the right.
    >
    > Interesting nevertheless is to see that the incoming mix is a
    > vapor as
    > it is visible. The fuel is still in small droplets, its a mist or
   fog.
    > Shortly after and specially when the piston comes up the fuel has
    > turnedinto steam (fuel steam) and the fuel becomes invisible.
    > After the spark, there is a light blue flame but not very
    > pronounced in
    > the whole chamber. The burn through is very quick.
    >
    > After that, or at the same time, there is a reddish flame on the
   right
    > that is very limited in it size and shape but keeps on existing.
    > I wonder why or what that is? Perhaps the temperature is lower
    > there, or
    > these are some pollutants or not fully burned matter?
    > Does anyone know more about that?
    >
    > I also wonder if the there was a small 'flood light' used to make
    > it all
    > visible. Normally it would be pitch dark (all black) in there.
    >
    > Also of interest would be to see a diesel engine. There the fuel is
    > injected at high pressure and is immediately ignited and burned.
    > One could probably see how far into the chamber it will travel
    > before it
    > gets ignited. What would the colors be like?
    > Would there also be some reddish flames besides the main blue and
    > practically invisible flame as in the above gasoline engine?
    >
    > Regards
    > Rolf Pfeiffer

   Rolf, another interesting question is why the intake valve is turning?
   If you watch the whole vid, you'll see a white mark on it as it slowly
   rotates around.. in reality that valve is probably spining near the
   engine rpm..

   I'd suspect that we're seeing an injected engine w/ injectors which
   are right up close to the intake. If it had been carburated I'd think
   that it would have been more of a continous stream of intake
   vapors instead of the concentrated one that we do see.. However,
   if it had been carburated.. we'd probably have been less likely
   to have seen any vapors due to them evaporating more before
   arrival at the valve???

   Interesting vid none the less..

   Jarrett


Vapor caused by local adiabatic cooling caused by the piston rapidly
dropping - increasing the volume - and fuel?

Piston engines use valve rotators - part of the retainer.  I don't know
how fast they normally turn the valve, and whether they explain what we
are seeing...


Regards,

Matt-

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.