There are a couple things I would like to know if it is possible to ask
someone before official stuff ends up in magazines and build ups, etc
for this motor when it comes out. How are the alum side housings
managing the exhaust heat? I assume that they are using those inconel
inserts Paul had mentioned to me but how are they getting them to fit at
the jucntion between the wear surface and that insert? Any word on the
official coating process used to make these things survive? Casting
material info?

Rob Woods

Too early to know Rob.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.