With the bosses already in place it looks like you could P port that
Copper state rotary and just move the carburetors over.

I increased the taper on my needle valve and flowed 18.32 GPH at 3 PSI
and 13.48 GPH at 2 PSI. My needle valve is 7/16th Dia and tapers .020"
over 1 3/8 inches.
I don't like the idea of a mechanical fuel pressure gage in the cocpit
(ignoring the 29 gal fuel tank) so I might go with a flow meter for
leaning control. Karibian


I think you might need a positive displacement mechanical pump to make that system work well.

Paul Lamar

Karibian,

Wouldn't an O2 sensor and digital display be better than fuel pressure gauge
or flow meter.
George (down under)

Apples oranges and peaches.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.