Hi Paul and All,
Couple of Photos for Your Up-Date,
Have changed the pulleys to install the 36-1 tooth Edis wheel,
Got things taged together, rough fit for vibration test run.
Radiator is 10 x 12 x 1.25 Avid Flyer part.
Couple of questions,

 1. Whats the deal in the exhaust port,
     the small down angle tube retained by roll pin?
 2. Do I stay with stock 12A timing useing Edis-4 Setup.
     Leading   0   TDC
     Trailing  20 ATDC
Best Regards
Rolland

Rolland,
What sort of carb is that - it looks like an old Posa.
I like your engine brackets and do you have a damper on that PSRU.
What sort of PSRU is that?
George (down under)


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.