Subject: 12A SIngle Rotor Timing
From: Rotary Engine
Date: 11/2/2007, 8:10 AM
To: AARotary Engine



Hi Paul and All,
Couple of Photos for Your Up-Date,
Have changed the pulleys to install the 36-1 tooth Edis wheel,
Got things taged together, rough fit for vibration test run.
Radiator is 10 x 12 x 1.25 Avid Flyer part.
Couple of questions,

 1. Whats the deal in the exhaust port,
     the small down angle tube retained by roll pin?
 2. Do I stay with stock 12A timing useing Edis-4 Setup.
     Leading   0   TDC
     Trailing  20 ATDC
Best Regards
Rolland



I am using 23deg fixed on both plugs. Throttle response is normal, mixture
looks good on O2 ang EGT. Running up to 6000RPM and WOT getting 27" MAP.
Single point ignition driving 12A coils on the test stand. Power seems to be
within expectation.
I dont have real good data points yet. My rotating parts need to go for
dynamic balancing before I do more running above 5500RPM.
I am running a P-Port, and compound side housings, consisting of aluminum with cast iron insert.

Richard Sohn
N2071U


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.