> Hi Paul and All,
> Couple of Photos for Your Up-Date,
> Have changed the pulleys to install the 36-1 tooth Edis wheel,
> Got things taged together, rough fit for vibration test run.
> Radiator is 10 x 12 x 1.25 Avid Flyer part.
> Couple of questions,
>
> 1. Whats the deal in the exhaust port,
> the small down angle tube retained by roll pin?
> 2. Do I stay with stock 12A timing useing Edis-4 Setup.
> Leading 0 TDC
> Trailing 20 ATDC
> Best Regards
> Rolland
Rolland,
What sort of carb is that - it looks like an old Posa.
I like your engine brackets and do you have a damper on that PSRU.
What sort of PSRU is that?
George (down under)
George,
Engine is from E-Bay No history/Info.
See photo's of HD PSRU has no damper.
Carb is POSA also have Makuni 42mm.
Question is dynamic balance, I need to do test run!
Rolland (Philippines)
Kitfoxes RP-S135/S2804
Rolland,
The Posa is the forerunner to many slide carbs of today.
.
I'm doing my own slide carb and some of the slide carb problems have to do
with sticking slide. I believe I have solved that by using bearings.
The Aero Carb is a slide as is the Ellison and many more.
Do you need some advice on dynamic balance of a single rotor, if so I am
more than willing to share advice given to me. I am also developing a
single
rotor.
George (down under)
Well lets hear it.
Paul Lamar ...No rotor no motor.
Paul, Rolland and Richard.
Advice to me is that dynamic balance should include the weight of a full
rotor of oil, all rotor seals except the apex seals and springs. It is
suggested that the Apex seals and springs weight is taken by the rotor
housing and therefore not part of the rotating mass. There's not much in it
either way.
The different rotors have different cavities and therefore carry different
amounts of oil, so each rotating assembly should be checked individually.
I intend using an RX8 rotor and for my own benefit will check to see how
balanced the rotor is in itself. The RX7 rotors have the balancing letters
stamped on them.
Now I have measured the RX8 and RX7 rotors and found about 3mm difference in
the depth of the area under the apex slot, the Rx7 being deeper. I have cut
3mm apex seal slots in the RX8 rotor and there appears to be plenty of metal
depth left, for the necessary strength in this area. I mention this as there
appears to be a difference of opinion, in if this can be done or not.
Now if you disagree, as some do, all I can say is that is best advice
available to me.
George (down under)
The rotors are never completely full of oil and the amount of oil in them
varies as they make their way around the inside of the engine.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.