Subject: 12A SIngle Rotor Timing
From: Rotary Engine
Date: 11/4/2007, 4:44 PM
To: AARotary Engine


     > Hi Paul and All,
     > Couple of Photos for Your Up-Date,
     > Have changed the pulleys to install the 36-1 tooth Edis wheel,
     > Got things taged together, rough fit for vibration test run.
     > Radiator is 10 x 12 x 1.25 Avid Flyer part.
     > Couple of questions,
     >
     > 1. Whats the deal in the exhaust port,
     > the small down angle tube retained by roll pin?
     > 2. Do I stay with stock 12A timing useing Edis-4 Setup.
     > Leading 0 TDC
     > Trailing 20 ATDC
     > Best Regards
     > Rolland

    Rolland,
    What sort of carb is that - it looks like an old Posa.
    I like your engine brackets and do you have a damper on that PSRU.
    What sort of PSRU is that?
    George (down under)


    George,
    Engine is from E-Bay No history/Info.
    See photo's of HD PSRU has no damper.
    Carb is POSA also have Makuni 42mm.
    Question is dynamic balance, I need to do test run!
    Rolland (Philippines)
    Kitfoxes RP-S135/S2804

Rolland,
The Posa is the forerunner to many slide carbs of today.
.
I'm doing my own slide carb and some of the slide carb problems have to do
with sticking slide. I believe I have solved that by using bearings.
The Aero Carb is a slide as is the Ellison and many more.

Do you need some advice on dynamic balance of a single rotor, if so I am
more than willing to share advice given to me. I am also developing a single
rotor.
George (down under)

Well lets hear it.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.