Subject: 12A SIngle Rotor Timing
From: Rotary Engine
Date: 11/4/2007, 9:22 PM
To: AARotary Engine



      > > Hi Paul and All,
      > > Couple of Photos for Your Up-Date,
      > > Have changed the pulleys to install the 36-1 tooth Edis wheel,
      > > Got things taged together, rough fit for vibration test run.
      > > Radiator is 10 x 12 x 1.25 Avid Flyer part.
      > > Couple of questions,
      > >
      > > 1. Whats the deal in the exhaust port,
      > > the small down angle tube retained by roll pin?
      > > 2. Do I stay with stock 12A timing using Edis-4 Setup.
      > > Leading 0 TDC
      > > Trailing 20 ATDC
      > > Best Regards
      > > Rolland
      >
      > Rolland,
      > What sort of carb is that - it looks like an old Posa.
      > I like your engine brackets and do you have a damper on that PSRU.
      > What sort of PSRU is that?
      > George (down under)
      >
      >
      > George,
      > Engine is from E-Bay No history/Info.
      > See photo's of HD PSRU has no damper.
      > Carb is POSA also have Mikuni 42mm.
      > Question is dynamic balance, I need to do test run!
      > Rolland (Philippines)
      > Kitfoxes RP-S135/S2804



Would appreciate all info I can get on single rotor balancing!
Exhaust port small tube with roll pin, is 13b the same?
How has this been closed?
Rolland (Philippines)
Kitfoxes RP-S135/S2804


Exhaust port is probably the same as a 13B.

Here is the mathematical correct way to balance the single rotor.
The PSRU you have is based on a six pinion  modified Ford C6 planetary
transmission part from Performance Automatic. Later on
Ford themselves starting manufacturing a six pinion planetary that
is interchangeably with the parts you have.

-----------------------------------

Opss wrong chart. Here is the better one.


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.