Rotary Engine wrote:
Every few months or a year the subject of the exact rotary engine
displacement comes up yet again. Here are a few indisputable facts.
Anybody near a rotary engine that is running can verify
these facts.
1. The one rotor rotary engines fires once per revolution
of the E-shaft. Easy to check. Stick your finger in the spark
plug lead :)
2. The displacement volume of one chamber of the Mazda rotary is
40 cubic inches. One can verify this by filling the combustion
chamber with a measured amount of oil through the spark plug holes
when the rotor is at bottom dead center.
3. The rotor rotates at one third of the e-shaft RPM.
Just look at the rotor phasing gears.
How then is one 40 cubic inch rotor chamber full of fuel
and air able to fire once per revolution of the eccentric
shaft?
There will be a prize for the first correct answer.
Paul Lamar ...No rotor no motor.
-------------------------------------------------------
Because there are 3 rotor faces - thus 3 chambers to go through the "4 cycles" of ICE,
and the phasing gears make each of 3 chambers complete their cycles once per
revolution of the e-shaft.
-dave Arbogast
------------------------------------------------------------
1/3 * 3 = 1. Doc Custer
----------------------------------------------------------
The 4 phases of combustion, intake, compression, ignition, and exhaust
take place in one rotation of the rotor. Each face of the rotor is in a
different phase of combustion so as face 1 is in the intake phase, face
2 is in the compression phase (arbitrary designations). These
activities are happening simultaneously. In one revolution, each
face has a combustion event, three faces, three events, three
rotations of the e-shaft.
Bob White
----------------------------------------------------------
Paul,
The rotor forms 3 chambers, 1 of which will pass into firing position per
revolution of the e-shaft.
Bill Jepson (unless I'm missing something here)
-----------------------------------------------------------
Um.. 'cause the rotor has three sides/chambers to it??
Jarrett Johnson
-----------------------------------------------------------
The E-Shaft turns at 3 times the rotor rpm, Virgil Salisbury
------------------------------------------------------------
Bzzzt! The "rotor chamber"(*) is
*much* more than 40 cubic inches. I
think you meant the "portion of the rotor chamber partitioned off by the
apex seals." And there are 3 apex seals, so there are 3 partitions
phased 120 degrees apart. Since the rotor "rotates"(**) at a 1:3 ratio
with the eccentric shaft, then each partition fires once per eccentric
shaft rotation.
Russell Kent
(*) The rotor chamber is that void inside the housing where the rotor
moves about.
(**) Really the rotor follows an eccentric path while rotating about its
center. But we'll simply call this "rotating".
------------------------------------------------------------------
Paul,
Due to the 3 lobes on the rotor, you have all the required cycles required
to run occurring concurrently in a single rotation of the eccentric shaft. I
want to see you do that with a single piston engine!
Larry Childs
-------------------------------------------------------------------------
There are three chambers per rotor and since each of those fire once per
rotor revolution only one will fire per e-shaft revolution.
This doesn't answer the question of displacement, though. It's not
clear to me how it should be measured. Is it the volume of all the
chambers in the rotary engine (analogous to the volume of all the
cylinders in a reciprocating engine)? That would require three
revolutions of the e-shaft to get power out of all the chambers. Our
beloved 13B would have to be renamed 39B. Mazda chose not to do it that
way. I'm sure there is some fallacy in my understanding of the volume
calculation for the rotary. I'm looking forward to learning the facts.
Dave Detty
-----------------------------------------------------------------------
One third of the eccentric shaft revolution is what it takes for the rotor
face to complete intake, compression, combustion and exhaust.
Alfonso Lebron
---------------------------------------------------------------
Because there is three such chambers for each rotor!!??
Steve Izett
Perth WA
---------------------------------------------------------------
I probably am not the first however...The answer is : One 40 cubic inch
rotor chamber full of fuel and air is able to fire once per revolution of
the eccentric shaft because their are three faces on the rotor and they each
fire for each revolution of the eccentric shaft, even though the rotor is
turning at one third the rpm of the eccentric shaft.
Norm Deboer
------------------------------------------------------------------------
Each surface of the single rotor engine completes the sequence of intake
compression combustion and exhaust in three e-shaft revolutions.
Looking at the rotor that will turn clockwise you count the fireing order
of the rotor by counting the surfaces counter clockwise.
For every revolution of the E-shaft the previously counted
surfaces will systematically complete the power stroke.
Therefore you have one power stroke for every e-shaft revolution.
Kenneth McKenzie
-----------------------------------------------------
I'll let you the readers be the judge. You can vote on the winner if you wish. I'll tally
the votes when I get back.
The displacement of all internal combustion engines are calculated on
the amount of volume each cylinder displaces times the number
of cylinders.
Since the rotary has three 40 cubic inch chambers in the one rotor engine
is the displacement 120 cubic inches?
If not what then is the real equivalent displacement of the Mazda rotary engine and why?
The key is to study the operation of the two cylinder four stroke piston engine.
This is the closest analogy to a one rotor Wankel.
Hint: Note that in one revolution of the 2 cylinder 4 stroke piston engine only one of
the two cylinders fires. In the next revolution the other cylinder fires and so on.
BTW This is and the high RPM of the Wankel make piston engine ignition coils
unsuitable for the rotary.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.