?????????????? > Carb Venturis and tuned p-ports appear to be mutually
incompatible :) ??????????????????
Uh, carbs were all that was used on P-port engines for MANY years.
Btw, engine ran better than ANY of the other runs. Medium stand off but it
pulled right through it without any nasty noises. That big flat spot on
bottom where I have to pull the load valve WAY back moved up 300 rpm (to
about 5500), but then the engine came out of it much easier.
Mazdatrix Inc.
2730 Gundry Ave.
Signal Hill, Ca. 90755
Phone: 562-426-7960
Fax: 562-426-9646
www.mazdatrix.com
For some strange reason the optimum intake length on the RX8 p-port engine is
different than the 13B p-port. It is a shorter length. This one is 19 inches
long. Perhaps it has to due with the reduced overlap.
In any event Dave Lemon worked his Weber tuning magic on the silly Weber and obviously
got it to work well enough.
I'll settle any day for 264 HP and 194 foot pounds of torque at only 7200 RPM.
This is the runner length to use for the 2.85:1 gear box.
Who needs a 16X? :)
I'll bet even Mazda would like to have 194 foot pounds of torque in the RX8 :)
Mazda needs to do the trap door p-port version with variable length runners.
The EGT's track amazingly well and the 1600 degree F temperatures are
a vast improvement over the 1800 F of the 13B. This will allow the turbine
on the turbo compound version to last a lot longer or run at a higher
RPM.
Thanks Dave.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.