Subject: Simple Stand-Alone Ignition -- WAS: Re: RX8 p-port pictures.
From: Rotary Engine
Date: 11/20/2007, 9:58 AM
To: AARotary Engine


> The engine goes maximum rough and a ton of fuel air mist
> eight feet high appears over the carb intakes.
...
>
> I was pleasantly surprised to find out the 2nd gen front cover
> water pump and ignition distributor fits the RX8 engine with a change
> to a 2nd gen drive gear on the nose of the RX8 e-shaft.
> That makes for a very simple stand alone ignition system.
> -- > Paul Lamar ...No rotor no motor.

Paul -

1) We want pics of that 8' mist demon.

2) 2nd gen front cover & Renesis compatibility is good news. Is this
news? Or did someone (but not us) already know this? IIRC, the 2nd
gen front cover provides for a low height water pump, right?

3) Stand-Alone Ignition should be discussed further ... or is there
history of that discussion that I missed? Options include:
- a) Magneto
- b) Simple sensor-triggered coil firing (sensor->transistor->coil)
- c) Complex microcontroller solutions (picaxe, etc.)

-Vince Orton

Actually the RX8 water pump is the best.

Some of the ignition options have been discussed.

Here is another picture of the mist.
-- Paul Lamar ...No rotor no motor.

Paul, another possibility for the stand alone ignition is the magneto
CDI used by some of the 2 cycles. (motorcycles and outboards) They are
dessigned for high frequency ignition events of course and there are
versions that would operate without a battery. The outboard units are
tough too since they are designed to operate inside a very tight cowling.
Bill Jepson


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.