Subject: Needle valve slide carbs. Was P-port
From: Rotary Engine
Date: 11/25/2007, 8:04 PM
To: AARotary Engine


I don't know why I did not think of this a couple of years ago.
I just was not thinking fixed needle movable fuel jet.
This is by a factor of ten simpler and easier to build than anything I have come up with
so far. It uses a low pressure pump and a low pressure pressure regulator.
Your done!!!! Assuming you have a slide throttle. Adjust the regulator to lean.
Turn the pump on after the engine is turning over to start.
To prime turn the pump on for a second or two and then off.

Paul Lamar ...No rotor no motor.

Paul,
This seems to be a fixed needle, (with integral needle and jet) x 2.

Wouldn't the fuel therefore need to be fed to the other, thicker end of the
needle.The biggest draw-back of a fixed needle is getting the fuel to the
jet, as the jet would be in most cases moving with the slide.

You have designed around this problem but I do see a couple of things to
consider, like the thickness of the needle- rod , but that is just a
relative thing ( i.e. fuel flow to air flow). I would personally go for the
flat ground needle to maintain more width thickness of the needle, therefore
keeping the needle diameter down to the smallest size.

One of the claimed draw-backs of the round ground needle is that it tends to
rub against the jet wall in one area and causes uneven wear of the jet, that
leads to an uneven flow distribution. However where it's one piece like
this, there isn't that sort of problem.

I may be wrong but I thought that round ground needles needed the increased
signal of a venturi to better draw the fuel. That's why I like the flat
ground needle as it creates it's own low pressure area behind the needle,
which draws the fuel up through the jet. Then again you mentioned the low
pressure pump and Regulator to initiate and maintain correct fuel flow. I
will use the same system but just enough pressure to get the fuel to within
striking distance, to respond to the low pressure area created by the flat
ground needle.

If I am seen to be pushing the flat ground needle, it's just because I would
like both yourself and Doug to fully understand the benefits, before you
eliminated it as a contended for a design.

One other thing to consider is fuel cut-off, but I suppose you will just
cut-off the fuel pump?

George (down under)



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.