Subject: Needle valve slide carbs. Fuel pressure regulator
From: Rotary Engine
Date: 11/27/2007, 3:05 PM
To: AARotary Engine

I found these pressure regulators at Pep Boys for about
$20. They are so cheap you can use two. One for each rotor
and lean them according to the EGT.
You push in the knob and rotate it to control the pressure from
one psi to 5.5 psi in about .2 psi increments. Release the knob
and it locks in place. I would use them with
a fuel pressure gauge to monitor what was happening.
They come with three different size plastic hose barbs.
Six in all.

The knob is marked at .5 psi increments. Mount two on the
instrument panel for leaning out the engine. One for each rotor.

www.spectreperformance.com
\
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.