Subject: Needle valve slide carbs. Fuel pressure regulator
From: Rotary Engine
Date: 11/27/2007, 7:23 PM
To: AARotary Engine

   I found these pressure regulators at Pep Boys for about
   $20. They are so cheap you can use two. One for each rotor
   and lean them according to the EGT.
   You push in the knob and rotate it to control the pressure from
   one psi to 5.5 psi in about .2 psi increments. Release the knob
   and it locks in place. I would use them with
   a fuel pressure gauge to monitor what was happening.
   They come with three different size plastic hose barbs.
   Six in all.

   The knob is marked at .5 psi increments. Mount two on the
   instrument panel for leaning out the engine. One for each rotor.

   www.spectreperformance.com <http://www.spectreperformance.com>
   \
   Paul Lamar ...No rotor no motor.


Are those 1/8" NPT fittings?  If so, I'd probably adapt to AN hardware.
Otherwise it looks okay.


Regards,

Matt-

Yes I think they are 1/8th NPT. The dyno engine will never fly so
I'll stick with the plastic fittings for now.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.