Subject: Needle valve slide carbs. Was P-port
From: Rotary Engine
Date: 11/27/2007, 2:12 PM
To: AARotary Engine


"The problem is the slide has a throw of about 2", and adjustment of needle
valves in the range of liquid flows we are interested in, happens in less
than a 1/16" linear travel, hence the need for several revolutions of the
knob to fine adjust them."

You are talking about a very short needle here. Apples and oranges. A long needle
works in a carb BECAUSE it is long. Two inch long needles are ad-van-tages and
not a drawback. The longer the better. Here is a needle curve out of a Posa
carburetor. The diameter of the needle can be adjusted along its length.
There are half a dozen brands of long needle carbs that work fine.

Unfortunately PWM is NOT working too well in aircraft. Besides the
extra expense, users have trouble installing, tuning and maintaining the
PWM EFI system. Most people are not electronic technicians let alone EE's. It is
way overkill for the average aircraft engine. Manually tuned aircraft
carbs also have years of proven research and use behind them too :)
We need something Joe Sixpack can understand and fix :) Present
company excepted :)

What works in a piston engine may not work in a p-port rotary. See my
last message.

Paul Lamar

Doug,
My primary goal is KISS, to achieve that the most simple yet safe system
possible- avoiding electronics wherever possible, that's why I suggested the
manual pump to Paul. However different people are comfortable with different
degrees of complexity and although electronics are great, my personal
concern is that when they fail, everything dependant upon them, fails as
well.

Why I am attempting my own carb is because I'm not comfortable with tuning a
complex and costly carb - mind you I haven't yet found one to suite my
application. The more simple ones ( like Aerocarb) are usually too small, as
this is their (demand driven) market.

As for the needle, I have opted to have 10mm of adjustment, which is massive
travel for a carb needle, I figure than I will have 5mm each way, this still
leaves about 3mm in the jet after full lean travel . It may take a few turns
of the leaning knob, and it may be a bit more than it is now in carbed
aircraft. I have opted to use Metric fine thread, where coarse would be
better suited, but at this stage I just am not sure, so I stick to fine
(1.25 pitch).

I know that our designs are different ( Paul's and mine) but I believe our
goals are essentially the same, it could be your design is totally different
again. I look forward to see it!

I have included a lot of info with my responses to, and discussions with
Paul, knowing he may not fully agree on certain points, but my hope was that
these points would serve as 'Grist for the Mill' for your development as
well.
George ( down under)


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.