I don't know why I did not think of this a couple of years ago.
I just was not thinking fixed needle movable fuel jet.
This is by a factor of ten simpler and easier to build than anything I
have come up with
so far. It uses a low pressure pump and a low pressure pressure regulator.
Your done!!!! Assuming you have a slide throttle. Adjust the regulator to
lean.
Turn the pump on after the engine is turning over to start.
To prime turn the pump on for a second or two and then off.
Paul Lamar ...No rotor no motor.
I am having some aluminum material blanks cut today.
If anybody is interested in a low cost kit of slide
throttle parts let me.
The big 2 inch holes will be cut in the 2 1/8th thick cover plates.
The .375 thick spacer will be machined out with notches for the springs.
These are the hard parts. You drill the small holes.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.