Subject: Needle valve slide carbs. Was P-port
From: Rotary Engine
Date: 11/30/2007, 9:38 AM
To: AARotary Engine


> I don't know why I did not think of this a couple of years ago.
> I just was not thinking fixed needle movable fuel jet.
> This is by a factor of ten simpler and easier to build than anything I
> have come up with
> so far. It uses a low pressure pump and a low pressure pressure regulator.
> Your done!!!! Assuming you have a slide throttle. Adjust the regulator to
> lean.
> Turn the pump on after the engine is turning over to start.
> To prime turn the pump on for a second or two and then off.
>
> Paul Lamar ...No rotor no motor.


I am having some aluminum material blanks cut today.
If anybody is interested in a low cost kit of slide
throttle parts let me.

The big 2 inch holes will be cut in the 2 1/8th thick cover plates.

The .375 thick spacer will be machined out with notches for the springs.

These are the hard parts. You drill the small holes.


Paul Lamar


I bought enough cut 6061 T6 material for ten Posa type carbs. In it's current 3 pcs
state it it is sawed to the outside dimension only plus or minus 1/32th. If anybody
wants one of the material kits send me $40 cash. One each front and back .125 thick
plates and one .375 inch thick spacer.

I also got a quote for ten pcs 6061 T6 material included,
spacer only from:

Integrated Ideas & Technologies, Inc.
3896 N. Schreiber Way, Coeur d'Alene, ID  83815
208-665-2166 or fax 208-665-5906

For just the spacer alone milled to final size inside and out for $38 each.

Less the material I got a quote for water jet cutting the inside
and out side. 10 pcs for $22 each. You still need a mill to smooth
the cuts. Cheaper to just machine it to start with.

This is a cheap way to go as a dual 58 or 51 mm Weber cost well over a $1000
and you can't easily lean it. Two 50 mm Mikunis or Keihins or Ellisons will
set you back REAL BIG bucks. Well over $2000.

I plan on making several different tapered needles so I can change them
on the dyno. A higher angle taper on the high end to richen the mixture
works on the Posa.

BTW Doug, you can't do that with a .25 inch long needle :)

Paul Lamar ...No rotor no motor.

Blake C. Lewis

Paul,
I would like one slide throttle kit. Give me an address to send the money.
Blake

830 East Santa Maria St.
Suite 303  >>>>very important<<<<<
Santa Paula CA 93060

Thanks Blake.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.