Subject: Needle valve slide carbs. Was P-port
From: Rotary Engine
Date: 11/30/2007, 10:51 AM
To: AARotary Engine


Paul.
   Can you have 4 flanges made also? Or 2 extra side plates I can cut
down for flanges.
Blake

The reason I choose 1/8th thick instead of 3/16th thick for the
front and back plates is I am going to simplify the design further.

I am going to TIG weld the 180 degree bend
two inch dia. .065 wall aluminum intake runners directly to the front plate and
two short two inch tubes .065 wall directly to the back plate. Much simpler to
attach the slide throttle carb system to the engine with a couple of short hoses
and four hose clamps. It is lower cost and there are no flange alignment
problems when you build the P-port rotor housings. Not to mention a
savings in nuts and bolts. Much quicker to take the slide throttle/carb
off and on as well.  Probably can be done  one tenth of the time. Not
to mention the time and cost of making the flanges.

The welding cost is the same.


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.