These are likely to be expensive as the
English pound to dollar exchange rate is not that great.
However if you need them you need them :)
--
Paul Lamar ...No rotor no motor.
Paul,
This is great if we could find somebody on this side of the pond the whole
intake tract could be made out of this and a couple of pieces of straight Al
tube with some injector bungs welded in or bell mouths to work with your low
pressure injection system.
Joe Berki
Limo EZ
I had the water plumbing in mind :)
As long as the slide throttle is next to the engine
it would work as intake runners.
--
Paul Lamar ...No rotor no motor.
All, My company uses Purolator orange silicon hose for turbo connections. We
have 1/8" wall X 2",2,1/8", 2 1/4", 2 3/8",2 1/2" & 3" ID on the shelf in 3'
length and we cut it for shorter lengths. If anyone needs some we would be
glad to help, just call 860-873-0100 and then dial extension 203 for parts.
Tom/norpro
Nice to know Tom but we mainly need water pluming in the 1 3/8" to 1 1/2"
sizes. Especially 90 degree and 45 degree units.
We only have a few turbo's flying right at the moment.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.