Subject: Low pressure mechanical fuel injection progress.
From: Rotary Engine
Date: 12/10/2007, 9:52 PM
To: AARotary Engine

It is coming right along. We found a center less grinding
outfit 10 miles from Santa Paula in the small town
of Fillmore Ca that has agreed to do a range of fuel needles
for us. Very convenient. The precision of this
needle is crucial. One thousands of an inch difference
of diameter can result in a change of fuel/air mixture.
The grinding outfit can hold 1/10 of a thou accuracy.
We will have a range of needles that we can change
during the dyno test until we find one that gives a
reasonable mixture across the RPM and load range.

If anybody wants to build one of these my friend
Jim Poole can machine the hard part for you. Fortunately he
has a right angle milling head for his Bridgeport mill
as that is what it takes to drill the long needle hole in the
slide. There is not enough vertical travel in the mill head
and foot.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.