Subject: Fuel cloud = Intake reversion / "Stand-off"
From: Rotary Engine
Date: 12/12/2007, 12:16 AM
To: AARotary Engine



 > > Hi Paul and others,
 > >
 > > I was quite puzzled on that "fuel cloud" phenomenon, have never
 > > seen/heard it before. I'm not sure if it was fully covered before,
so...
 > >
 > > I found this discussion thread when looking for info about nox
boosting.
 > > It's quite good on explaining the thing.
 > >
 > > "Fuel stand-off - intake reversion - what are the causes?"
 > > http://www.eng-tips.com/viewthread.cfm?qid=190526&page=1
 > >
 > > Originally i got the name for phenomenon from this article:
 > >
 >
http://www.carcraft.com/techarticles/116_0406_nitrous_350_chevy/index1.html
 > >
 > > There was some papers listed later on thread:
 > >
 > > "Intake bell-mouth effects"
 > > http://www.profblairandassociates.com/pdfs/RET_Bellmouth_Sept.pdf
 > >
 > > NACA paper on induction manifold dimensioning
 > >
 >
http://ntrs.nasa.gov/archive/nasa/casi.ntrs.nasa.gov/19930090861_1993090861.
pdf
 > >
 > > NACA paper on induction manifold dimensioning - pipe length
 > >
 >
http://ntrs.nasa.gov/archive/nasa/casi.ntrs.nasa.gov/19930084998_1993084998.
pdf
 > >
 > > And later, article about exhaust manifolds
 > > http://www.ssheaders.com/header.htm
 > >
 > > Cheers,
 > >
 > > Petri
 > >
 > > I first noticed this around 1965 on 800 HP small block V8 Chevy
 > > Chaparral racing engines. The fuel mist was being blown away by the
 > > speed of the car. This is what I did about it. I designed this
 > > air box and had it installed on the Chaparral 2D and the problem
 > > went away. Perhaps just out of sight and out of mind. The car went
on to
 > > win the Nurburgring road race in Germany so it obviously worked.
 > > As far as I can tell this was the first ram air box on a race car.
 > > Now common practice on almost all race cars today. Of course the P38
 > > and the Me109 used similar ram air boxes years before.
 > >
 > > Last year's 245 HP 2nd gen 13B p-port had it. This year's 264 HP RX8
 > p-port
 > > engine had it in spades. You can find a video of it on the web site.
 > > http://www.rotaryeng.net/intake.html
 > >
 > > This years engine generated 20 more HP. Both in the same
 > > 7300 RPM range. Strangely this year's engine had 3 inch shorter
runners.
 > > Both had downdraft Weber carbs as did the Chap. 1965 V8 Chev.
 > >
 > > Although we did not run it above 4000 RPM I did not notice it on Mark
 > > Suspinski's 13B p-port engine when running with EFI and 25 inch
runners.
 > > That is not to say it won't do it at higher RPMs. Mark should have
 > > constructed an air box by now.
 > >
 > > I suspect it has to due with the carb venturi. Air must be shooting
 > > out of the intake runner sucking more fuel out of the float bowl and
 > > then back into the engine. I think the engine is flooding
 > > with excess fuel. In other words the mixture is probably down
 > > around 8:1 or worse. IMHO the engine is drowning with fuel.
 > > The BSFC is real bad when this happens and the engine stumbles.
 > > So too is the gallons per hour read out from the dyno flow meter.
 > >
 > > Perhaps one way of dealing with it is to restrict the size of the
 > > fuel hose to just enough to get peak power at 12.5:1 I am going to try
 > > that on the low pressure fuel injection I am now building.
 > >
 > > Paul Lamar ...No rotor no motor.
 > >
 > > ----------------------------------------------------------------------
 > > Petri,
 > >
 > >
 > > This report "Intake bellmouth effects" is great.
 > >
 > >
 > > Paul,
 > >
 > > Thank you for the photos of the Chaparral. At the time of that
 > > Chaparral Nürburgring victory (living not far from there) I was just a
 > > little boy, but knew the car from my racing car pack of cards (?) very
 > > well. Reading my first motorsport magazines some years later I
learned,
 > > that the win of this single American car with its automatic
transmission
 > > versus all the Ferraris and Porsches was really a sensation on that
old
 > > hilly racetrack. For me this is one of the nicest race cars up to now.
 > >
 > > Reiner
 > >
 > > Thanks Reiner. Other than the ram air intake box I had little to do
with
 > > that design. I had a lot more to do with the 2F design and that is
 > why it is
 > > so different than the 2D. The 2D body was done by stylist mostly while
 > > I tried to bring low drag aerodynamic principles to the 2F design
shown
 > > here.
 > > It was so different in fact that I had to fight for it within the
 > > organization.
 > > Some people thought it ugly. Consequently it still looks modern to
 > this date
 > > 40 years later.
 > >
 > > The ram air box was built in to the rear of the body. The front and
 > > rear panels were Plexiglas so the driver could see through it.
 > > The carb air intakes were just above the rad air intakes on either
 > > side of the car. The car was required to carry a spare tire by
 > > the rules. One could see the reversion by looking in the inside
 > > rear view mirror. Also note the oblique mounted radiators. Another
 > > feature years ahead of it's time.
 > >
 > > The 2F set lap records at race tracks all over Europe that stood for
 > > a couple of years but the transmission was under-developed and broke
 > down in
 > > every race except the last one. The BOAC 500 at Brands Hatch England
 > > where the 2F won.
 > >
 > > Consequently the 2F is my favorite Chaparral.
 > >
 > > Paul Lamar ...No rotor no motor.
 > >
 > >
 > > Paul
 > >
 > > I just found my book "Chaparral" by Richard Falconer/Doug Nye. This 2
F
 > > had really some amazing new details (especially that big rear wing) ,
 > > which became common to most racing cars of the next generations. So
 > > congratulations for that, even if 40 years to late. Are there more
books
 > > (technical side) of that Chaparrals in the US?
 > >
 > > Reiner
 > >
 > > The first edition of that book was not very accurate. Both Jim Hall
 > > and I called him on it and he modified the book in a later edition
 > > adding an appendix in the back with information from me. Pete Lyons
 > > wrote a small 96 page book or pamphlet called CARS IN PROFILE NO4.
 > > The Chaparral 2, 2D and 2F. Profile Publications Limited, Coburg
 > > House, Sheet Street, Windsor Berkshire, England. Whew!
 > >
 > > Apparently it is very rare as google
 > > knows nothing about it. Pete lived at my house in California when
 > > he wrote much of it in 1972. As far as I know Pete is still alive and
 > > living in Big Bear California. I have not been in touch with him
 > > since 2002. Pete is also a pilot. Here is his last known to me
 > > email address.
 > >
 > > Pete Lyons <bigbearlyons@earthlink.net>
 > >
 > > I have one or two other books on the Chaparral at the hangar.
 > > They contain mostly photographs.
 > > --
 > > Paul Lamar ...No rotor no motor.
 >
 > Paul:
 >
 > I have the "Cars in Profile" Vol. 4 that has the Chaparral article in
it.
 >
 > Would you like the rest of the photos scanned in, and the article text?
 > I have an old computer, but I can try. :-)
 >
 > Les Nordman
 >
 > Thats OK Les. Thanks. I have the book. Perhaps somebody else
 > on here would like it. Can you make a pdf of it?
 >
 > Paul Lamar ...No rotor no motor.

Paul:

Yes, I will scan the articles and its photos and try to make a .pdf of
it.  It will be an adventure! :-)

Les Nordman :-)

Paul:

 In the late 60's I would drive to Watkins Glen to watch Jim Hall and the
Chaparral's race. As I recall they were open cockpits. When did they change
to the more streamlined closed cockpit?

Tom/norpro

We raced in two classes. The Can Am was an open sports car class in
the US and Group 6 was a coupe. Mostly in Europe.

Very different rules. Their was no minimum weight in either class.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.