Dear Mr. lamar,
Thank you for your very informative website. I have
visited it many
times and learn a bit more each time. I am in the
process of
designing the FWF for a Glasair Sportsman 2+2 with a
Mazda 2-rotor
engine. The cooling is a true challenge, in that I
would prefer not
to have to do it over and over again until I get it
right!
Your website describes the motor mount for a Glass
Star (Glastar?),
which uses the same firewall as the Sportsman. Can
you tell me who is
flying the Glastar with the rotary? Or have them get
in touch with
me? I would like to learn from the experience that
they have gained.
You show a drawing of the motor mount for a Questair
(http://
www.rotaryeng.net/rv6load.gif)... there is a "PAN
DETAIL 4X SCALE" in
the drawing.... is this using the pan itself as part
the motor mount?
I have been considering a redesigned pan structure
that would include
the lower two motor mounts. The Sportsman has a 5th,
top-center
firewall hard-point that can be used to support the
top of the engine
to make a three-point mount that reaches nearly to
the vertical plane
of the CG of the engine/reduction/prop package.
Thanks in advance for any information.
Best regards,
Tom
Thomas Lowell
The oil pan is not really part of the motor mount.
It is modified to accommodate the Schertz Beam and
increase
the oil capacity. The more oil that is in there the
longer
it takes to heat it up. So there is less oil cooling
required on takeoff and climb out. My O-470 has 12
quarts.
Also check out: http://www.jerryhey.com/
Here is Sigard Ganswindt rotary powered Glasair
Sportsman.
Nice job. I don't have an email address for him.
Paul Lamar ...No rotor no motor.
Am I mistaken or is that a clear glass or plastic tube
in the coolant line in the left side view photo?? Look
at the bottom hose clamp. Karibian
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.