If anybody is thinking of trying this with a throttle body
mounted where the mass air flow sensor is mounted don't do it.
It will collapse the box when the throttle is closed.
It is designed for a slide throttle mounted near the engine.
It could be beefed up to do that by making it out of
1/4 inch thick PVC foam and glass or carbon fiber on
both sides.
Paul Lamar
That the setup I have, airflow sensor followed shortly by throttle. The
plenum and runners are made of pvc tubing segments joined with
fiberglass. Plenum is 6" dia. round pvc with a wall about 3/8" and the
four runners are 1-1/2" and 2" pvc pipe, joining a sawed-off piece of
the aluminum stock intake manifold that has the secondary injector fuel
rail.
It has worked for several hundred hours now. But I suppose knowing the
vacuum limit on the stuff would be good to know.
Perry
A six inch round plenum is a lot stronger than a 9 by 8 by 4 inch high
box.
A four inch square extruded aluminum plenum will also work fine with a
TB.
Paul Lamar
You got me worried about my pvc pipe intake manifold, but a quick google
search shows:
http://www.uni-bell.org/faq.html
Q: Can PVC pipe withstand a vacuum? If so, what is the maximum vacuum
that PVC pipe can withstand?
A: Yes, PVC pipe can withstand vacuum pressures. According to research
conducted by Dr. R.K. Watkins at Utah State University, vacuum pressures
cannot collapse an underground PVC pipe that is properly encased in a
soil envelope and exposed to normal service temperatures. In fact,
quick calculations show that even under conditions of elevated operating
temperatures of 100oF, the pressure required to collapse most PVC pipe
is greater than atmospheric. In other words, the pipe can withstand a
complete vacuum.
Vacuum pressures are generally not considered a favorable occurrence in
water distribution systems of any pipe material. However, if the
effects on the entire system are taken into consideration, PVC offers
adequate strength and safety to withstand vacuum pressures.
Perry Mick
If you build a ram air box out of sheet metal for use with just a mass
air flow sensor make it with all the flanges out board. I suspect we lost
at least one engine in the air when a bolt or rivet worked its way out
of a ram air box and was ingested into the engine taking out an
apex seal. With all the flanges on the out side of the box this is not
possible. The top of this box will be transparent Lexan so I can see
spit back if any. I plan on using this one on the dyno.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.