Jerry and Paul,

Attached is the revised 801 firewall drawing containing the upper mount
point on the firewall.  The drawing is attached in both PDF and
AutoCAD2007 in the event that you can import the drawing into your 3d
modeling software.  Jerry, hopefully the dimensions will be visible on
the PDF.  Let me know if you would like me to increase the font on the
.dwg as well.

The upper mount point bolt holes (3/8') are located 380 mm above
the firewall horizontal center line and 38 mm on both sides of the
firewall center line.  The bolts on the upper mount point will pass
through the firewall and then attach to a 40mm x 100mm plate on the
cabin frame thereby connecting the mount to the upper cabin frame.  This
was mentioned by Kenny A on the list in a message from yesterday.

Please let me know if you need any other information concerning the 801.

Thanks
Pat


I think I can import dwg but the pdf is fine. No need for the dwg.
I used the pdf file to generate these jpg's

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.