Subject: Minor break through in turbo compound.
From: Rotary Engine
Date: 2/6/2008, 10:42 AM
To: AARotary Engine

I finally found a cutaway of the Detroit Diesel DD15
blow down turbine. It appears that an axial flow turbine is used and is the
hot tip as opposed to a radial flow turbine as used in turbo chargers.
The same type Curtiss Wright chose. Also the plumbing can be more direct
further conserving the exhaust heat.

It makes sense as a larger diameter axial flow turbine will have the same
HP at a lower RPM due to more torque easing the reduction gear
box requirements. Overall a more efficient design than the
Scania high RPM radial flow turbine. It also opens up the possibility
of internal air cooled turbine blades.

This brings us back to one of my original ideas.
It will be necessary to include a variable vain nozzle to broaden
the benefit of the turbo compound not shown yet in this 3D.
The Mazda rotary again has an advantage due to its high RPM which
reduces the diameter and weight of the blow down turbine and
potentially eliminates the need for a gear box. Of course it has
no exhaust valves than can waste half the kinetic energy in the exhaust.

The diameter shown in this 3D is not necessarily the correct
diameter for a direct drive turbo compound rotary. The advantage of
direct drive is to limit the gear box losses.

To cut the cost of R&D you always start with what works and go from there.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.