> Hi Paul,
> Do you have a supplier name for the vibration absorbing rod ends shown
> in the pix with the water pump mod's? Commonly they are used to support
> the back end of Jerry's oil pans. I've tried McMaster Carr but find only
> metal to metal rod ends. Any suggestions? Thanx Dave M
>
>
> They are not on the McMaster web site nor are they in the new catalog
> but they still sell them. You must call and ask for the part number.
> Part number is 6088K15 for the 1/2 inch male. You must also specify left
> or right hand tread. If you screw a right hand into a threaded hole
> it would be CW and a left hand would be CCW. If you make a link
> with right hand thread on one end and left hand thread on the other
> you don't have to take it all apart to adjust the down thrust angle.
> The Questair venture is very successful using this design. One can
optimize
> the top speed by adjusting the down thrust angle.
>
> McMaster never tells you who makes the parts.
>
> http://www.midwestcontrol.com/catdisplay_short.php?pg=209
>
>
>
> Paul Lamar ...No rotor no motor.

You might inquire of Aurora.  They are in Aurora, IL near Chicago.
Yogi


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.