Subject: SAE paper on turbo compounding
From: Rotary Engine
Date: 2/23/2008, 10:10 PM
To: AARotary Engine


   A few years ago some SCCA rotary road racers had discovered the lower
   the oil temp the more the power. It did not dawn on me
   why that was necessarily true until I read the SAE paper I just up
   loaded.

   Here is the reason. The volumetric eff. of the engine is being
   affected by the temperature of the face of the  rotor which in
   turn is being cooled by the oil.

   Keep the oil hot during cruise for best BSFC and cool for max power.

   ------------------------------------------------------------------

   A 6% improvement in the BSFC would drop the BSFC from the current
   lean burn .47 to about .44 which is about the same as a Lycoming.

   The typical cruise fuel burn would go from about 10 GPH to about 9.4
   GPH.

   Easy to do. Just put a cowl flap on the oil cooler air outlet.
   Not only will that warm the oil during cruise it will cut the
   aerodynamic drag. This has pertinence  in endurance road racing as
   well as aircraft.

   -------------------------------------------------

   Come to think of it this is also why the rotary BSFC is so much
   better at higher power levels compared to what it is in a car piston
   engine.
   Mazda needs to find a way to turn off the rotor oil cooling
   squirter's under
   typical low power car cruise. In other words they need to find a way
   to get more
   heat in the rotors at 4,000 RPM at the 30 and 40 HP power levels
   typical of 80 MPH
   cruise. I would not be a bit surprised if this did not increase the
   EPA highway
   numbers by one or two MPG.

   --
   Paul Lamar ...No rotor no motor.

    > This is about all low heat rejection engines. Not just turbo
   compounding.
    > Good list of references on other work.
    >
    > Paul Lamar ...No rotor no motor.


   Paul


   So it looks like we need an rotor that is light weight, strong and has
   insulating properties.  Titanium.  The recessed area within the
   rotor faces
   could be steel to absorb and retain heat.

   Can't imagine how expensive this rotor would be:)



   Doug in Japan

   I am thinking stainless Steel. Easy to cast and I think it does
   not conduct heat as easily as cast iron. I am still looking into it.
   You can still cool the bearing without cooling the combustion surface.

   ----------------------------------------------------
   http://hypertextbook.com/physics/thermal/conduction/

   Iron  ......80 .... Current
   SS ........ 14 ...  Cheap
   Plain steel 45 - 65
   Titanium... 22 .... Expensive

   --
   Paul Lamar ...No rotor no motor.


What about a ring of insulating material
as a thermal break?

-Jeff Martin


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.