Subject: Oil to water heat exchanger data
From: Rotary Engine
Date: 2/25/2008, 4:48 PM
To: AARotary Engine


           I went back and checked some old messages prior to
   installing the
           oil water
           HX but you never mentioned OAT or climb. Do you remember
   what that
           may have
           been?

           "To answer your question on water temps; the water temps
   were never
           a problem.
           They would stabilize around 135-150, depending on MAP."

           Sounds like your glycol system was very effective if not
   over kill.
           Do you recall the size of the rad?

           Paul Lamar ...No rotor no motor.


       Paul,
       The application was Ford Galaxy (probably w/390ci engine, but not
       stated).  Core size is 18 x 22.5 x 2.5, best I recall.  Initial
   flight
       was in August and the temps were in the mid 90's.

       Mark S.


       You obviously did a great job on the rad ducting. Core volume
   appears to
       be about 1000 cubic inches where our rule of thumb call for 300
       cubic inch
       per rotor or about 900 at the max for a 3 rotor.

       What I can't understand is why the oil cooler is not working better.
       Perhaps you have some air leaks in the front duct or the back side
       of the oil
       cooler is too hot. Can you make some air temps measurements behind
       the oil cooler?
       What brand of oil cooler is that?
       --
       Paul Lamar ...No rotor no motor.


   It appears the oil cooler and glycol cooler exhaust into the same
   chamber/plenum (main volume of the cowl..  If the delta-P across the oil
   cooler is larger than the delta-P for the glycol cooler, it might
   explain the difference.  Maybe the oil cooler is thicker?  Is there room
   for a dedicated duct for the oil cooler to the outside of the cowl -
   maybe out the left side adjacent and aft of the cooler?


   Regards,

   Matt-


Matt,
Yes, the oil cooler is 3/8" thicker than the glycol exchanger.  Also,
maybe more significant, is that the fin count is much higher for the oil
cooler, resulting in higher drag/pressure drop across it.  I had
considered adding a dedicated exit duct for the oil cooler, but didn't
want to pay the drag penalty.  That's when I decided to try the
oil-to-water exchanger.  The beauty with that solution is that it didn't
cost me any additional cooling drag. I feel that if I could fit a
slightly larger glycol exchanger in place of what I'm running now, that
I could eliminate the oil/air exchanger altogether.  I even flew with
50% of the oil/air exchanger blocked off.  It was pretty close with the
current glycol exchanger, but not quite enough to fly in Texas in the
summertime.  So, I left the oil/air exchanger in place and don't have
any more cooling problems.  That's a real good feeling.

Mark S.


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.