Subject: SAE paper on turbo compounding
From: Rotary Engine
Date: 2/25/2008, 5:26 AM
To: AARotary Engine


The more I think about a low conduction SS rotor the better it looks. I suspect
a disproportionate amount of combustion heat is going into the rotor
and thence into the oil raising the BSFC.
 >
 > Paul Lamar

Make the new RX8 rotor also 7-8 CR, and we have a wonderful rotor for
turbo engine.
Cheers, Petri

Good idea. We can sell them to the RX8 engine people with a lower
compression ratio for turbo charging. The current 10:1 RX8 rotors
are really unsuitable for turbo charging.
Paul Lamar

Every RX8 tuner wants a pair of these. This could finance the whole
project.
Things to take care of first could be:

High rotor face temp on WOT.
Lower thermal conductivity translates to higher surface temp?
We don't want this on high boost. Makes the knock situation worse on
high power, also volumetric efficiency would suffer, offsetting our gain
on IMEP somewhat. But how much - and should we care?

On 75% cruise, this is likely to be just fine. Together with 250F/16psi
glycol-water coolant, there could be clear gains on BSFC compared to
baseline engine.

But car tuners are mainly interested on how much peak power they could
get, and that's the biggest market...

Apex seal groove friction
Boost stresses are higher due to 14-28 psi boost possible. Is SS up to
task by itself?
Cheers,
Petri

Once the patterns are made you could cast either in iron or SS.
If there was enough meat you could machine the combustion chamber
on an NC mill. Make heavier high CR SS for the RX8 car cruise market with
a lower red line. Make lighter low CR iron for the turbo RX8 market.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.