A few years ago some SCCA rotary road racers had discovered the lower
the oil temp the more the power. It did not dawn on me
why that was necessarily true until I read the SAE paper I just up loaded.
Here is the reason. The volumetric eff. of the engine is being
affected by the temperature of the face of the rotor which in
turn is being cooled by the oil.
Keep the oil hot during cruise for best BSFC and cool for max power.
------------------------------------------------------------------
A 6% improvement in the BSFC would drop the BSFC from the current
.47 to about .44 which is about the same as a Lycoming.
The typical cruise fuel burn would go from about 10 GPH to about 9.4 GPH.
Easy to do. Just put a cowl flap on the oil cooler air outlet.
Not only will that warm the oil during cruise it will cut the
aerodynamic drag. This has pertinence in endurance road racing as
well as aircraft.
-------------------------------------------------
Come to think of it this is also why the rotary BSFC is so much
better at higher power levels compared to what it is in a car piston
engine.
Mazda needs to find a way to turn off the rotor oil cooling squirter's
under
typical low power car cruise. In other words they need to find a way to
get more
heat in the rotors at 4,000 RPM at the 30 and 40 HP power levels typical
of 80 MPH
cruise. I would not be a bit surprised if this did not increase the EPA
highway
numbers by one or two MPG.
-- Paul Lamar ...No rotor no motor.
Paul,
With modern electronic flow control valves it would be easy to slow the
flow to the oil cooler with a bypass system. It would take a
sophisticated system to determine when you were going into the cruise
mode but it would be possible. You have hit upon a way to improve basic
BSFC without drastic changes. Couple that to lean running enabled by
direct injection and the rotary would be competitive even before adding
turbo compound, and much better after adding it.
Bill Jepson
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.