> Does anyone have left over teflon for a slide throttle? Or, does
   anyone
    > need some if I buy a sheet?
    >
    > --
    > Blake C. Lewis
    >
    >
    > I'll buy whats left if nobody else wants it Blake and keep it
   around until
    > somebody needs it. What thickness are you planning on buying?
    > --
    > Paul Lamar ...No rotor no motor.

   Paul/Blake, I'll take one of the kits for the slide throttle. Where
   did you
   get the velocity stack/EFI setup?

   Rick in Alaska

   I don't have any more kits. Blake has the Teflon.
   I'll send his email address by private.

   The 2 inch OD .065 wall 180 bends came from Burns Stainless.

   --
   Paul Lamar ...No rotor no motor.


Paul,

Did anyone ever come up with a 3-rotor version of the slide throttle.
There's getting to be quite a few of us tripple-rotorheads out here.

Mark S.

Not yet. One problem is the Teflon comes in 12" by 12" sheets which
is not long enough for a 3 rotor. It gets real expensive if you buy it
in larger sheets.

I have some ideas for cutting the cost of the Teflon as it has
gone sky high lately. It requires a bit of additionally machining however.