Subject: Opps I just invented something again
From: Rotary Engine
Date: 2/26/2008, 6:29 PM
To: AARotary Engine




    A manually controlled over pressure valve. When your airplane
    starts spewing steam disable the valve and pump in cold
    cooling water from an emergency reservoir supply until you get
    it back on the ground. If you don't disable the valve you have to
    pump it in at over 30 psi.
    --
    Paul Lamar ...No rotor no motor.



Emergency spray bars - mist onto the rad inlet - would work great on
Mark's layout since it would then blow any remaining water over the
entire engine.  Cool the system, lower the tendency to boil.  How much
flow do you need?  A windshield washer pump probably isn't enough.
Maybe the domestic water pump from a travel trailer?  How about a
pre-pressurized tank, or a CO2 cartridge which would pressurize the
emergency tank.  How much water to haul?  1 gallon?  2?


Matt-

Evap water sucks down a lot of heat. Called the heat of vaporization
as I recall. It don't take much.

BTW Matt Please set your left margin to zero.
-- 
Paul Lamar ...No rotor no motor.

Paul,
Use a 50/50 mix of methanol and water for spray. Better evap provides even
more cooling. On the yak we run water spray bars on the oil cooler and run a
15 minute race at max power with the oil cowl doors closed. We use about 3
quarts per minute, but we are cooling a 1600 horse power radial. You need a
pump with a little bit of pressure so the water is a good mist coming out of
the spray bar. The spray bar is nothing but a 3/8 stainless tube with .020"
holes drilled in it. Our pump is an RV water supply pump for semi trucks as
we are 24v. 12v ones are very cheap, made of plastic so they are light.
Trick it to put it on an arm switch and have a coolant temperature switch
turn on the pump and alert the pilot. You want to slow down the problem
before you boil over to give you some air time to get down.
Larry


Translates to .375 quarts per minute at 200 HP. At that rate a gallon (8 pounds)
will buy about ten minutes. Pretty good unless you are out in the middle
of nowhere. 200 MPH is 3.33 miles per minute or 33 miles in ten minutes.
I think a 3 gallon tank (24 pounds) would not be out of the question.
Almost 100 miles. Maybe a little bit of both. Make up water and spray bar.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.