Subject: Opps I just invented something again IMPORTANT
From: Rotary Engine
Date: 2/27/2008, 4:11 PM
To: AARotary Engine


>      A manually controlled over pressure valve. When your airplane
>      starts spewing steam disable the valve and pump in cold
>      cooling water from an emergency reservoir supply until you get
>      it back on the ground. If you don't disable the valve you have to
>      pump it in at over 30 psi.
>      --
>      Paul Lamar ...No rotor no motor.
>
>
>
> Emergency spray bars - mist onto the rad inlet - would work great on
> Mark's layout since it would then blow any remaining water over the
> entire engine.  Cool the system, lower the tendency to boil.  How much
> flow do you need?  A windshield washer pump probably isn't enough.
> Maybe the domestic water pump from a travel trailer?  How about a
> pre-pressurized tank, or a CO2 cartridge which would pressurize the
> emergency tank.  How much water to haul?  1 gallon?  2?
>
>
> Matt-
>
> Evap water sucks down a lot of heat. Called the heat of vaporization
> as I recall. It don't take much.
> Paul Lamar ...No rotor no motor.



> Paul,
> Use a 50/50 mix of methanol and water for spray. Better evap provides
even
> more cooling. On the yak we run water spray bars on the oil cooler
and run
> a
> 15 minute race at max power with the oil cowl doors closed. We use
about 3
> quarts per minute, but we are cooling a 1600 horse power radial. You
need
> a
> pump with a little bit of pressure so the water is a good mist coming
out
> of
> the spray bar. The spray bar is nothing but a 3/8 stainless tube with
> .020"
> holes drilled in it. Our pump is an RV water supply pump for semi trucks
> as
> we are 24v. 12v ones are very cheap, made of plastic so they are light.
> Trick it to put it on an arm switch and have a coolant temperature switch
> turn on the pump and alert the pilot. You want to slow down the problem
> before you boil over to give you some air time to get down.
> Larry



> Translates to .375 quarts per minute at 200 HP. At that rate a gallon (8
> pounds)
> will buy about ten minutes. Pretty good unless you are out in the middle
> of nowhere. 200 MPH is 3.33 miles per minute or 33 miles in ten minutes.
> I think a 3 gallon tank (24 pounds) would not be out of the question.
> Almost 100 miles.
>
> Maybe a little bit of both. Make up water AND spray bar.
> --
> Paul Lamar


-----------------------------------------------------------

Same idea as emergency core cooling in a Nuclear Power plant :-)

Bill Schertz
KIS Cruiser #4045
N343BS (reserved)

Wow! Cool! I did not know that.


--------------------------------------------------------------
VERY IMPORTANT:


BTW Bill, how do you convert BTU to Horse Power.

If I use http://www.onlineconversion.com/energy.htm

They 1 000 Btu = 0.393 014 802 horsepower hour

Are BTU based on minutes so that is really .393 X 60 = 25.58 HP?

I am trying to get a handle on the size and capacity of this oil cooler.

This is the ONLY oil cooler I have good and complete data on.
Both air side and oil side.

Paul Lamar

Hi Paul,
 This may help:    multiply horsepower  by 42.4  to obtain  BTU per
minute.   Dave M




The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.