Subject: Opps I just invented something again
From: Rotary Engine
Date: 2/27/2008, 4:05 PM
To: AARotary Engine



   A manually controlled over pressure valve. When your airplane
   starts spewing steam disable the valve and pump in cold
   cooling water from an emergency reservoir supply until you get
   it back on the ground. If you don't disable the valve you have to
   pump it in at over 30 psi.
   --
   Paul Lamar ...No rotor no motor.



   Emergency spray bars - mist onto the rad inlet - would work great on
   Mark's layout since it would then blow any remaining water over the
   entire engine. Cool the system, lower the tendency to boil. How much
   flow do you need? A windshield washer pump probably isn't enough.
   Maybe the domestic water pump from a travel trailer? How about a
   pre-pressurized tank, or a CO2 cartridge which would pressurize the
   emergency tank. How much water to haul? 1 gallon? 2?


   Matt-

   Evap water sucks down a lot of heat. Called the heat of vaporization
   as I recall. It don't take much.

   BTW Matt Please set your left margin to zero.
   --
   Paul Lamar ...No rotor no motor.

   Paul,
   Use a 50/50 mix of methanol and water for spray. Better evap
   provides even
   more cooling. On the yak we run water spray bars on the oil cooler
   and run a
   15 minute race at max power with the oil cowl doors closed. We use
   about 3
   quarts per minute, but we are cooling a 1600 horse power radial. You
   need a
   pump with a little bit of pressure so the water is a good mist
   coming out of
   the spray bar. The spray bar is nothing but a 3/8 stainless tube
   with .020"
   holes drilled in it. Our pump is an RV water supply pump for semi
   trucks as
   we are 24v. 12v ones are very cheap, made of plastic so they are light.
   Trick it to put it on an arm switch and have a coolant temperature
   switch
   turn on the pump and alert the pilot. You want to slow down the problem
   before you boil over to give you some air time to get down.
   Larry


   Translates to .375 quarts per minute at 200 HP. At that rate a
   gallon (8 pounds)
   will buy about ten minutes. Pretty good unless you are out in the middle
   of nowhere. 200 MPH is 3.33 miles per minute or 33 miles in ten minutes.
   I think a 3 gallon tank (24 pounds) would not be out of the question.
   Almost 100 miles. Maybe a little bit of both. Make up water and
   spray bar.
   --
   Paul Lamar ...No rotor no motor.


   40 psi is a good pressure to mist water.  Water has over twice the
   cooling capacity as methyl alcohol (Latent heat of evaporation for:

   water = 540 cal/gm
   methyl alcohol = 262 cal/gm
   ethyl alcohol = 204  cal/gm).

   Latent heat of vaporization is the quantity of heat necessary to
   change on gram of liquid to vapor without change of temperature,
   measured as calories per gram.

   Pure water would give the greatest  heat transfer.  This said, one
   must consider the minimum and maximum temperature that the stored
   liquid would see.  Alcohol can be added to forestall  freezing even
   though it reduces the evaporative heat capacity of the water.

   Joel



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.