Subject: Mazda aluminum side housings revisted.
From: Rotary Engine
Date: 3/5/2008, 1:50 PM
To: AAA Put this in the To box

I found an old SAE paper 730119 on the OMC engine.
A very interesting paper.
I noticed that OMC had good luck with aluminum
side housings made from hypereutectic aluminum.
The same process used by GM on the Vega engine.
Does anybody have any direct experience with
OMC snow mobile rotary engine side housing wear problems?

I wonder how Silicon Nitride ceramic
side seals would work on hypereutectic aluminum.

Perhaps OMC was better able to control the casting
process than GM.

Paul Lamar ...No rotor no motor.

Paul,
I mentioned this before, and perhaps you heard differently through your
Chapparal contacts, but I was told the engine blocks on the Vega engine
worked fine by people in the know. Many other problems including valve
guides which caused most of the smokers rather than the block.The
Porsche 928 V8 and many of the current MB V8's use the same technology.
I thought this might be a good possibility, but I doubt that Mazda would
have missed it if that had been the case.
Bill Jepson



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.