Subject: Mazda aluminum side housings revisted.
From: Rotary Engine
Date: 3/5/2008, 9:24 PM
To: AAA Put this in the To box


    >> I found an old SAE paper 730119 on the OMC engine.
    >> A very interesting paper.
    >> I noticed that OMC had good luck with aluminum
    >> side housings made from hypereutectic aluminum.
    >> The same process used by GM on the Vega engine.
    >> Does anybody have any direct experience with
    >> OMC snow mobile rotary engine side housing wear problems?
    >>
    >> I wonder how Silicon Nitride ceramic
    >> side seals would work on hypereutectic aluminum.
    >>
    >> Perhaps OMC was better able to control the casting
    >> process than GM.
    >>
    >>
    >> Paul Lamar ...No rotor no motor.
    >>
    >> Paul,
    >> I mentioned this before, and perhaps you heard differently
   through your
    >> Chapparal contacts, but I was told the engine blocks on the Vega
   engine
    >> worked fine by people in the know. Many other problems including
   valve
    >> guides which caused most of the smokers rather than the block.The
    >> Porsche 928 V8 and many of the current MB V8's use the same
   technology.
    >> I thought this might be a good possibility, but I doubt that
   Mazda would
    >> have missed it if that had been the case.
    >> Bill Jepson
    >
    >
    > BMW had problems with the sulfur content in US gasoline eating up the
    > bore in their aluminum blocks on the 3L V8 (530i cars) - 10 years
   ago.
    > I haven't heard of more recent issues.
    >
    > Other question.. It's my impression that the apex seals take more
    > abuse than the side seals, and similarly the rotor housing wear
    > surface needs to be tougher than the side housing wear surface. Is
    > this correct? Does that allow using a coating that's less tough on
    > the side housing? It's apples to oranges, right?
    >
    >
    >
    > Regards,
    >
    > Matt-
    >
    > I would say yes Matt. Just an impression I get. However the side
   housings
    > wear more than the rotor housings. Once the ridges are over a
   couple of
    > thou the housings need lapping or replacing. I suspect the cast
   iron side
    > housings could benefit from the same chrome treatment given to the
    > rotor housings.
    >
    > The wear on the rotor housings are well within acceptable limits
   as long
    > as the apex seals remain intact. With the Mazda system of chrome over
    > steel.... cast iron apex seal wear is projected to be about 3,000
   hours.
    > With Silicon Nitride ceramic apex seals wear is projected to be
   30,000 hours.
    > Of course no one has worn out a ceramic apex seal yet.
    > --
    > Paul Lamar ...No rotor no motor.


   Paul,

   Ethanol fuels will dissolve unprotected aluminum.

   Doug

   Looks like it is out for Porsche's, BMW's and Mercedes.
   Not to mention all the other companies that are planning to
   switch to un lined aluminum cylinder bores.

   Paul Lamar ...No rotor no motor.



I assume the rotor housings on the Rotomax engines are custom to them.
DO they use a SIP liner or do they coat the rotor housing with the same
stuff they do the side housings?

Rob Woods

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.