Subject: Other info on the OMC
From: Rotary Engine
Date: 3/5/2008, 2:40 PM
To: AAA Put this in the To box

The charge cooling on the rotor was not very effective with the
rotor running almost 1000 F at 5500 RPM WOT. This had a strong
affect on the VE which was 60 to 70% partially due to an increase
in charge temperature of 100 F. A water cooled version would be
some what better in this regard. The OMC rotary was air cooled.
OMC felt the VE could have risen to 85 to 90% if it were not
for the 100 F higher heated charge. That is a hypothetical situation
as then the rotor would not be cooled.

The best BSFC was about .68 from 3200 to 4000 RPM.

EGT's were 1800 F in the exhaust port.

They did use a throttle plate close to the rotor housing intake
port similar to our slide throttle device to effect better running
at idle.

They used a very beefy and thick outer steel race for the
rotor roller bearings to help the well known problems with
those types of rotor bearings. Midwest engines also discovered
these problems. Here is a shot of the Midwest/Diamond
rotor and one of the Wankel Gmbh rotors. Both charged cooled
rotors.

OMC accumulated 15,000 test hours.


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.