Subject: Other info on the OMC/midwest
From: Rotary Engine
Date: 3/5/2008, 5:04 PM
To: AAA Put this in the To box



   The charge cooling on the rotor was not very effective with the
   rotor running almost 1000 F at 5500 RPM WOT. This had a strong
   affect on the VE which was 60 to 70% partially due to an increase
   in charge temperature of 100 F. A water cooled version would be
   some what better in this regard. The OMC rotary was air cooled.
   OMC felt the VE could have risen to 85 to 90% if it were not
   for the 100 F higher heated charge. That is a hypothetical situation
   as then the rotor would not be cooled.

   The best BSFC was about .68 from 3200 to 4000 RPM.

   EGT's were 1800 F in the exhaust port.

   They did use a throttle plate close to the rotor housing intake
   port similar to our slide throttle device to effect better running
   at idle.

   They used a very beefy and thick outer steel race for the
   rotor roller bearings to help the well known problems with
   those types of rotor bearings. Midwest engines also discovered
   these problems. Here is a shot of the Midwest/Diamond
   rotor and one of the Wankel Gmbh rotors. Both charged cooled
   rotors.

All,

Pardon my naivety in terms rotary, or engines in general.

I assume that by charge cooling you refer to the intake charge( air or
air/fuel combination) cooling the mechanism thence entering the
combustion chamber to be burned.  If I am wrong, discontinue reading
this post.

I am not familiar with the OMC but am very familiar with the Midwest. (I
have one which powered my dragonfly for a couple of years.)

In the Midwest/Diamond, the fuel-air charge does not, at any time see
anything other than the combustion chamber. The carburetors or the
injectors are right next to the intake ports on the engine. The intake
air goes from the filter into a plenum (on top of the engine) then
through two tubes to either the carbs or injector bodys. The trochoid
lubricating oil is injected directly into the ports (intake)

The rotor cooling and internal lubrication is something totally
different. The bearings are fed (gravity/metering pump-same as the
trochoid lubrication) with premix oil. They weep into the internals
(internal rotor, cooling veins, gear, main bearings, etc. On the back of
the engine is a belt driven turbine (looks like a turbocharger but is
not) the output of which picks up the wept  oil and blows it through the
mechanism cooling and lubricating the internals. The air/oil mixture
exits overboard into an air/oil separator and then overboard. The oil
that is caught by the separator is then scavenged and pumped back into
the oil reservoir.

As I said before, at no time does the air/fuel charge, or the air used
in the combustion process go anywhere other then into the trochoids. It
is not used, in any way for cooling.

Rich

You are absolutely correct Rich. My mistake. The Midwest rotor is
air cooled by a blower. That turbine you refer to above. The Midwest BSFC
is much better than the OMC engine.

Only the Wankel Gmbh rotor is charge cooled.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.