Subject: Mazda aluminum side housings revisted.
From: Rotary Engine
Date: 3/7/2008, 12:28 AM
To: AAA Put this in the To box


   I think Steve is probably referring to aluminum Chevy blocks. More
   modern aluminum
   engines have girdles to stiffen the main bearing area of the block.
   In line engines
   and V engines are always trying to shove the crankshaft out the
   bottom of the
   block. Consequently they are inherently heaver than horizontal opposed
   engines where loads from opposite cylinders balance out more or less.

   Honda engines are famous for main bearing girdles :) In some cases they
   are cast iron or even steel. The aluminum Jag V8 has a cast aluminum
   oil pan
   with steel inserts that doubles as a girdle.

   I drove both a Corvette with an aluminum block and a Jag XKS with an
   aluminum block. There was a world of difference at 6500 RPM. The Chevy
   felt like a hand grenade while the Jag engine was still smooth.
   This was part of a sports car test we did for Pop Science about six
   or so
   years ago.

   Paul Lamar

Paul,
I think it's funny that Chrysler and Desoto got it so right 50 years
ago! The thing a lot of people forget about the original "Hemi" is that
even more than the top end, the crank and block were the sturdiest
design ever to that point. The Crank bearing caps thru-cross bolted to
the deep skirt on the bottom of the block is exactly what the brand new
LS1 and LS5 engines are using. The oil pan is almost flat.

I have a question for Steve. Did you guys ever use a spring type washer
arrangement on the tension bolts to prevent "bolt bind" at high
temperature? We have talked about it on ACRE, but I have never actually
seen anybody use the idea of running belleville washers under the
tension bolt nuts.
Bill Jepson



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.