Subject: Three pcs end housings?
From: Rotary Engine
Date: 3/7/2008, 10:40 AM
To: AAA Put this in the To box


Paul, I have been thinking about this for some time... I really like
your idea about the aluminum side housings with the steel inserts with
the "O" ring seals. Here's an idea:

What if the stock Mazda gaskets were used and a simple steel side plate
was used with an extra side gasket with  an aluminum side plate of said
thickness between the 2 center side steel plates and single end steel
plates was used ? Much simpler to cast and machine. What do you think ?
KISS :-) Seams like center and end aluminum castings plates could be
milled on a Bridgeport, save for the steel plates.

-dave

Makes them three piece instead of two? It would probably work but it is
a lot of water seals. A lot cheaper than a hollow end housing. Probably
also cheaper than a hypereutectic end housing as well.


---------------------------------------------------------------

If we aluminum brazed the back piece on I think it might work.
Larry could do this in a heart beat. P-ports only which would
vastly simplify things. Heck JB Weld might even work.
REAL easy to try.

The steel wear plate could be through hardened and nitrided or porous chrome
plated.

Paul Lamar ...No rotor no motor.


Dave,

the attached picture is what I am using in my single rotor. I ran about
10hrs so far, with 5 at high power levels.

Richard Sohn
N2071U


I talked to Paul Yaw and he said it should be done. He said he will contact
you. I gave him your email address.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.