Subject: S-beam and oil pan
From: Rotary Engine
Date: 3/16/2008, 9:29 AM
To: AAA Put this in the To box



Paul,  since we started building the asymmetrical s-beam,  we have not
built a single symmetrical beam.    The asymmetrical beam is about 4
inches shorter overall.  I end up sawing off the end of the blank
beams.   What do you think about settling on the shorter length which
is 25.65D" overall, 23.65" between Barry centers.  The asymmetrical
beam allows more options but prevents none that I can think of.

On the oil pans,  I like the appearance and the additional clearance
gained by narrowing the bottom of the pans, from 10" wide to 8" wide
at the deep end.  What do you think about doing all of them in this
way?   Jerry

I think it is a good idea. Saves a bit of weight too.
That would give people the option of using the side or bottom rad.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.