Subject: Mazda aluminum side housings revisted.
From: Rotary Engine
Date: 3/17/2008, 3:34 PM
To: AAA Put this in the To box


Hey George;
I agree you don't want to remove a lot of chrome due to blow-by.
The chrome edges are already an early 13B failure point - chrome wear
will reduce
compression and flaking "could" contribute to the death of a seal.
The point is to take just enough chrome to reduce load on the chrome -
never heard an
exact number - 0.0005" ?
One of the folks I heard this tip from was LynnH.
Have you seen pics of his race housings - they look like new after years
of hard use...
Cheers
Cary

Never heard of that one Cary, however I have heard of trimming the rotor
corners, in racing in the Rx7 and especially in the Rx8. The e-shaft flex
causes them to bind on the end housings, a bit of reduction there solves the
problem. After later reflecting on what you said previously, I thought this
was what you may be getting confused with.

However if Lynn said it must be right -  not something I would consider as
the apex seal spring should take up any slight flexing.
George (down under)


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.