I have a Raven redrive on a 1.3L 16 valve Metro/Suzuki engine. A thrust
test of this design by another Raven customer reportadly achieved over
440 lbs of thrust near sea level with a 70"+ Powerfin prop. Raven
developed this drive to survive on the 1L (3 cyl) with 3 blade props.
The harmonics were tearing things up until rubber bushings were added in
a "cushion hub" design. The newest design does not use an outer bearing
on the crank.
Tracy Crook also uses rubber bushings to smooth out the hard power
pulses of the rotary engine.
These harmonics could also be the source of the problems with drive belt
on the mechanical fuel injection.
Dan
The outer bearing has nothing to do with the power pulses.
It is strictly there to mitigate the rotating bending loads
on the crank that lead to fatigue cracks. Leaving the bearing
off is a big mistake.
The torque isolators are there to extend the life of the belt.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.