Jerry,

As I mentioned on Paul's newsletter, the engine is:

1987
13B
turbo block
NA, (normally aspirated-no turbo)
Application:  Long-Eze

But:
Has a 12A front plate.

The 12A front plate means that a MM pick-up point on the
oil pan is not necessary and not desired.

So I can not say that the oil pan Hayes sent to me is for the
average Turbo block.  It may not be-but it is supposed to fit
the block they built for me.

As I would like to purchase the S-beam and oil pan from you, perhaps
you can take the measurements from the pan I will send, along with  those
from Paul's newsletter.

So if you can send me your shipping address I will send the oil pan  I have.

Regards,
Joe Graham

Joe,  as long as the  oil pan matches  your engine I can take a
pattern off for the new pan.   You say it is supposed to fit your
block. Just curious, is there some reason you cannot check it out?

Is the s-beam asymmetrical or  symmetrical? What is the distance
between Barry mount centers?  The Long Eze may be too narrow for a
full length beam which is 29" between centers and 31" overall.  If you
don't have this info, Paul can come up with it.   He could also
customize the pan shape for  your application if that were required.
It is a good idea to plan the entire engine mount so that we don't
find out later that the pan interferes with a motor mount tube or the
S-beam sticks through the side of the cowl.  :)

I understand you want just the s-beam and oil pan and not the complete
engine mount.   The price for the S-beam is $400.00 and the price for
the oil pan without rear bracket  is $350.00.  Regards,  Jerry

My address for shipping and mail is
3790 S. 600 W.
Albion, IN   46701



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2007 All world wide rights reserved.